1. Obeying the same as the usual quiet operation of the cutting machine. Strictly start the laser, dimming, and test machine according to the laser starting pace.
2. The operator must be trained, familiar with cutting software, set up equipment deployment layout, performance, and master the knowledge of the operating system.
3. Wear protective clothing according to the regulations, and wear protective glasses that are defined in the laser beam.
4. Do not process a material before it can be irradiated or cut with a laser to avoid the latent damage from smoke and vapor.
5. When the equipment deployment is started, the operator must not leave the booth or the person to be in charge. If it is necessary to stop, stop or block the power switch.
6. Keep the weapons in a safe place; turn off the laser or shutter when not working; do not arrange paper, cloth or other flammable materials close to the unprotected laser beam.
7. When the invention is very in the process of processing, it should be immediately shut down, and the obstruction or escalation of the supervisor should be cleared in real time.
8. The connected laser, the bald top, the bed and the surrounding garden are neat, orderly and oil-free, and the workpieces, plates and wastes are stacked according to the plan.
9. When using a gas cylinder, the welding wire should be prevented from being crushed to avoid the occurrence of power leakage. The use and transportation of gas cylinders shall be subject to the gas cylinder inspection procedures. Resist the cylinder in the sun or near a heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. Observe the high pressure quiet procedure during maintenance. Every 1 day of operation or weekly maintenance, every 1000 hours of operation or every 6 months of maintenance, according to the delineation and pace.
11. After starting the machine, the X, Y, and Z axes should be manually moved at a low speed to check the machine to check whether there is any environment.
12. After entering the new workpiece step, you should try it out and check its operating environment.
13. When things are happening, carefully inspect the operating environment of the machine tool to prevent the cutting machine from going out of the useful range of travel or causing chaos caused by two collisions.
14. Set the equipment deployment to be positively harmful in the active operation, and never enter the quiet fence. Any manipulation must be meticulous and quiet. No matter what time you enter the rigid operation, it will cause serious damage.
15. When feeding, you must look at the feeding state, so as not to cause the arching to hit the bald top, the result is severe.
16. Before the production operation, check whether all the preparations are in place, whether the shelter gas is turned on, and whether the air pressure is reached. Whether the laser is on standby. Feeding, dull, whether it is active.
Outdoor Camping Knife,Camping Defense Knife,Camping Folding Knife,Folding Camping Knife
YangJiang Junxiong Trading & Industry Company Co.,Ltd , http://www.cn-sundo.com