KCB stainless steel gear pump is a gear pump, specifically a kind of acid-resistant, wear-resistant gear pump. According to the design proposal provided by the utility model, the driving shaft and the driven shaft are mounted on the housing, the gear is mounted on a section of the driving shaft located in the housing, the gear engaged with the gear is arranged on the driven shaft to form a pair of gear pairs, The shell is provided with an inlet and an outlet for materials. The utility model is characterized in that a ceramic plate is arranged on the inner wall of the cavity for accommodating the gear pair in the shell. The device by changing the gear pump structure, to improve the gear pump acid and wear resistance. Stainless steel gear pump scope of application: This gear pump is suitable for conveying solid particles and fibers, corrosive, the temperature is not higher than 120 ℃, the viscosity of 5-1500cst of lubricating oil or other properties of similar lubricating oil. This series of gear pumps by changing the material and sealing can deliver high temperature oil below 260 °. When ordering must be marked (high temperature). Stainless steel gear pump purposes: In the oil transfer system can be used as transmission, booster pump. In the fuel system can be used as delivery, pressurization, injection fuel pump. By changing the pump material, asphalt insulation pump bearings and seals can be used to transport chemical raw materials and corrosive materials. In all industrial areas, can be used for circulating oil pump. Uses: In the higher sanitation requirements of the occasion, such as medicine, food industry: In a weak corrosive occasions, such as fine chemicals, cosmetics, printing and dyeing, brewing industry. Structural Features: KCB stainless steel gear pump consists of gear, shaft, pump body, safety valve, shaft seal and other components, the gear heat treated by a higher hardness and strength, together with the shaft installed in the exchangeable sleeve operation . The lubrication of all parts in the pump is automatically achieved by the use of conveying medium while the pump is in operation. The pump has a well-designed drain and return tank, the gear torque in the work to bear the smallest, so the bearing load, wear a small, high pump efficiency. The pump has a safety valve as overload protection. The full back pressure of the safety valve is 1.5 times of the rated pressure dispatched by the pump. It can also be adjusted according to actual needs within the allowable discharge pressure range. But pay attention to the safety valve can not be used for long-term relief valve, the need is to be installed separately in the pipeline.
Low Hardness O Ring,Acid Proof O-Ring,Vmq O-Rings
Xlong Seal Co., Ltd. , http://www.xmseals.com