In the renovation process, we not only need to consider the price of floor tiles, but also need to consider the price of workers sticking floor tiles . Only in this way can the cost of renovation be well controlled. Today, with the small series to see the price of floor tiles and floor tiles to pay attention to matters for your reference.
Sticker floor tile price
Prices in different regions will be different. Today, Xiao Bian said that it is now an average price, we can refer to: the level of man-made technology, generally ranging from 30 to 40 yuan per square meter. According to the days calculation, then 300 yuan per day! Paving bricks depends on the size of the brick!
Floor Tiles Precautions
1. First, the wall tiles should be laid up from the bottom up, and one wall can not be attached to the top at one time. The seams are generally 1~3 mm; the second is to deal with the smoothness of the wall surface to deal with cracks before paving; third is the bonding material. The smear should be slightly higher in the middle than it is around, and use a rubber hammer to strike the surface to fix it. This will prevent air from accumulating in the adhesive layer. At the same time to carry out the level of testing; Fourth, adhesive materials to pick and appropriate, the general wall cement and sand ratio of 1:4, the ratio of ground cement and sand 1:3
2, the ground should be tied. There are some civil grounds that are uneven. In this case, everyone should use the cement mortar to level uneven areas. When laying, different colored tiles (darker colors) can be used to frame the surroundings while the tiles in the frame are lighter. Of course, the floor of the kitchen and the toilet must have an inclination. This is to facilitate drainage.
3, tile decoration Another thing to note is the treatment of the waterproof layer. The walls in the kitchen and toilet areas should be highly noted. Because replacing the tiles usually damages the original cement pad waterproof layer. The remedy is to apply a layer of bituminous waterproofing before plastering. Tiles filled with white cement should also be filled.
4, the brick surface should be flat, the angle should be accurate, the interface should be on the line; the tiles should be immersed in water for half a day before use; the toilet floor should have a proper slope, can not use water after the white tile cement with white rattan brush clean white cement, Do not leave cement on the surface of the bricks. After the tiles have been laid, cover them with cardboard, etc., and wait at least 24 hours before walking on the tiles.
5, first sweep the net clean and wet, with 1:3 cement mortar primer, thickness 6 mm. The walls should be slightly hairy but they must be flat. To calculate the number of vertical and horizontal blocks, set a horizontal grid. Paste the tiles every 3-4 days after the bottom. When tiling, first wet the wall with water, place a pad ruler at the bottom of the bottom layer of the tile, and the ruler pad must keep the horizontal line and fix it. Tiles should be pre-saturated with water and taken out to dry slightly. Adding a proper amount of 3%-4% 107 gel in 1:2 cement fine sand can improve the workability of the mortar. Slow down the clotting time. To facilitate the paste and prevent mortar from flowing. Apply the mortar to the back of the tile, tap the wall and tap the brick surface with a rubber mallet to fill the mortar. After pasting the bottom layer of tile, place the vertical ruler as a vertical standard. When the paste is generally started from the angle of the sun, so as not to complete the alignment of the tiles in the seam. All the vertical and horizontal seams must be aligned. The mortar on the brick surface should be wiped off when it is dry. After the paste is applied, it should be rinsed with clean water, and the seam should be wiped with white cement. Lay a tile on the plaster wall of the mortar to find the vertical and horizontal reference lines on the wall. Calculate the number of layers, and paste it with cement paste mixed with 5%-7% of 107 glue. If the wall surface is very smooth, first use a pure cement slurry to sweep it again and start to paste it when it is not dry. Because the adhesive layer is not mixed with sand, it is very thin, only 2-3 mm thick, easy to flatten when bonded, so this is a very convenient and economical method.
6, set the ground standard height surface
(1) Spread a layer of 1:3.5 cement mortar on brushed floors to a thickness of less than 10 mm.
(2) Use nylon or cotton rope to pull out the ground elevation line at the elevation point of the wall and the vertical crossing positioning line.
(3) Lay the tile according to the position of the positioning line. Spread 1:2 cement mortar on the back of the tile, and then tile the floor with the floor, and hit the tile surface with a rubber hammer to make it compact with the ground, and the height is consistent with the ground elevation line. When applying more than 8 blocks, use a level ruler to check the flatness, and use a rubber hammer to level the high part, and use a cement slurry to raise the low part. Tile laying procedures, for small rooms (less than 40 square meters in area), are usually made as T-shaped standard height surfaces. For a large area of ​​the room, a standard height surface is usually formed by a cross in the center of the room, which can facilitate the simultaneous construction of multiple people.
7, paved big side
Paving large-surface construction is based on the paved standard height surface as the base. When paving, begin construction on the standard height surface that has been paved, and use the straight line drawn to control the straightness of the tile to the seam. When laying, the grout should be plump to dry the back of the tile and tapped with a rubber mallet to prevent emptying. And check the correction with a ruler while laying. And immediately wipe the surface of the grout.
For toilets and toilet floors, pay attention to the slope of the return water of 1:500.
The relevant information on the price of floor tiles has been introduced here for everyone. I hope this article will be helpful to everyone. If you still have something you don't understand, you can leave a message to Xiaobian at the bottom. We will answer your questions as soon as possible.
Floor Tiles Bathroom Tiles Tiles Tiles Floor Tiles Kitchen Tiles
Laminated Smart Glass,Smart Glass For Door,Smart Glass For Windows,Smart Glass For Partition
SHANDONG TOP LEADER GLASS CO.,LTD , https://www.topleaderglass.com